Low Lying fog, The NEWEST Cryo Device in years light weight Portable Cryo unit, Cryogate is the smallest compact unit that allows you to use your own DMX smoke machine for incredible results.

Get the proven Professional Results, when it has to be right you need Effect Specialist™

The NEWEST Cryo Device in years light weight Portable Cryo unit

Cryo Gate Table Top or Floor Model for Low Lying Fog Look Solutions 

With the ability to shoot long distances because of the use of high pressure co2, powerful smoke machine and the gate feature which alows more air higher flow for faster output speeds and higher fog levels.

Zigmont Magic FX Inc. - Effects Specialist® - Special Effects Designer - We provide the entire spectrum of Special Effects for Events Since 1990 Doing Cryo for 20 years!

The Low Lying Smoke & CRYO Cold Flow  Effect Specialist™ zigmont@zigmont.com 813.689.6269 zigmont@effectspecialist.com

The NEWEST Cryo Device in years Cryo Gate Table Top or Floor Model for Low Lying Fog Look Solutions  The Cryo Gate is an small 24"W x 8" H x 7" D which is an external CO2 device that can be put in front of any preexisting regular smoke machine. (use a DMX Smoke machine w/1200 watts or higher or rent one from us) It uses common high pressure CO2 to create a low-lying fog from the output of any professional fog machine, when an appropriate fog fluid is used. Can comes with an 8 inch 20 ft Black Hose. Can run analog with the following Protocols; preset panel, DMX, Ethernet, sACN Universes and IP Config. We use 20 pound co2 tanks which can be T together for longer run times or larger bottle used. Smoke flow for continuous flow should be 50% volume or less. You can burst smoke for under 40 seconds. Cryo Gate runs the smoke machine. Cryo gate is small and can be used with you DMX smoke machine, uses light weight and cheaper cost 20 pound bottles of co2 which lasts 5 min with a 20 pound bottle and 50 pound tank for 12 minutes and tanks can be T together and daisy chained bottles hoses. CryoGate Uses and runs 3 DMX Channels for DMX operation and has 3 preset for analog panel operation T- Unions can connect serval bottles The 3 DMX channels are as follows; Ch 1 smoke pump and volume control through the 2 inch opening the smoke machine needs to be 1/2 to 3/4 of an inch from the rear hole align centered. Ch 2 is the gate which is an electric control series of curved panels which open and close allow air to flow into the mix like a venturi flow allowing the fog to raise and more air allows higher output speed. The gate along which the high pressure co2 can allow fog to flow up to 60 foot x 40 foot See above The air can be adjusted with electronic shutters which act as a venturi. The Ch 3 controls the Co2 flow as the need for more smoke comes the need for more co2. Low co2 flow makes 4 inches high low fog in 1 min., med co2 flow makes 6 inched high fog in 1 min., high flow of co2 makes 8" of fog height fog in 30 sec.. On the preset  The DMX co2 flow usage. The menu tells you how much co2 was used. A tank is 18KG   You can preset your own settings as well. On the preset non DMX control Analog mode Front panel has menu and DMX 3 pin in andDMX 5 pin in/out , reat remote in and smoke machine DMX out for smoke machine.   The simple analog menu, we can add a DMX controller The video shows the cryo Gate on a table top for easy access to use.  The CryoGate is an external CO2 device that can be put in front of any preexisting regular smoke machine. It uses common high pressure CO2 to create a low-lying fog from the output of any professional fog machine, when an appropriate fog fluid is used. Manual for CryoGate